U.S. based support - Always available, always in-house, ready to serve you. Quality Services ...Expert Support.

FasterMac Turbo for Mac

Download:
Previous TurboMac Client OS X 10.3.x-10.5.x Updated September 2009
Older Turbomac OS X 10.2.8 client non Intel Client

TurboMac Software Installation

1) After downloading macupdate.dmg locate the file on your computer. In most situations the downloaded file will be on your desktop.
2) Double click on the macupdate.dmg icon, this will create and open a volume named TurboMac Accelerator on your desktop.
3) Double click on the TurboMac Accelerator .pkg icon located in the newly created volume.
4) Follow the on screen instructions to complete the install of the TurboMac Accelerator. Please note if you are not logged in with administrative access the installer will prompt you for the administrator username and password. You must supply this to continue with the install.
5) After following all on screen instructions the installation program will inform you the software was installed and ask you for your username and password, enter your fastermac.net (or TurboMac Universal) username and password and check the box to save password. You can now close the installation program by clicking on Close in the lower right corner. After closing the installation program you may begin using the TurboMac Accelerator.
6) After installing the TurboMac Web Accelerator it will automatically start. If you are not logged in with administrative access it will prompt you for the administrator username and password. You must supply this so the program can make required modifications to your network settings.

Usage

1) To use the TurboMac Web Accelerator you will need an active dial up connection. After insuring you have a dial up connection established locate the TurboMac Web Accelerator icon in the Applications Directory on your computer. To start the accelerator double click on the icon.
2) To begin surfing simply open your web browser and go to any site on the Internet you would like. If you did not provide an administrator username and password during the initial setup you may be prompted for one at this time. If you receive any other messages when you attempt to use the accelerator please refer the FAQ section. You can verify your connection is being accelerated by watching the TurboMac image on the status screen of the accelerator program.
3) To adjust the image quality the TurboMac Web Accelerator is set to simply slide the bar located on the Images screen of the accelerator program. The two sample images on that screen will change to show you how images on websites will look at the current acceleration level. When you are done adjusting the image quality setting click the apply bottom to save your changes.
4) To discontinue use of the Accelerator click on the X icon in the upper left hand corner.

top